Picking up where we left off in my previous post (Part 1)…
… while was waiting for my bench to dry, I worked on recovering the bench seat.
Step 1: Flip over and start pulling up the old fabric from the corners. Work your way around ripping up the fabric. Use scissors, pliers, or whatever tools needed to destroy any stubborn fabric refusing to surrender.
If there is another fabric layer discovered (like I’ve found on most of the treasures I pick up) simply repeat the stripping process until you uncover the actual “fluff” of the cushion. It should look something like the stripped cushion above.
Step 3: To add a little extra substance to your cushion, unroll a piece of quilting batting, lay the seat cushion and existing fluff face down on the batting, and cut out a piece of batting around with with about a 2 inch margin for wrapping around. Starting with the corners, wrap the batting tight around the edge and staple into place. Trim any excess batting.
Covered with a layer of batting, the seat should look something like this.
Step 4: Roll out your new fabric of choice, face down, over a flat clean surface. Place your batting covered seat cushion face down on the portion of the fabric you want to use. Depending on the pattern, you may want to hold in place and flip over to line up or center the pattern on the seat. (I chose a solid white linen I had extra yardage of from another project.) Cut out your fabric around the seat cushion, with a 3-4 inch margin to give you wiggle room to adjust the pattern placement. Trim off any excess fabric.
Step 5: Similar to step 3, pull tight, wrap the fabric around the edge, and staple in to place. Begin with a corner, follow with the corner diagonally across from it. Then the third corner, then the last corner diagonally across from it. Picture stretching an artist canvas – you want it pretty tight! Then fill in with as many staples as needed along the edges to hold tight and not pucker. It should now look something like the seat cushion above
Step 6: This was a total experiment. I wanted to do an insert border of grosgrain ribbon, without cutting, sewing, etc. I would have normally tried ironing it on with Stitch Witchery, but alas, all I had in my cabinet at the moment was Liquid Stitch. (Which was also a total experiment.) I laid out the ribbon where I wanted it, pulling tight, pinning, and pleating to turn corners as I went. Once it was all laid out, I went back and turned up the edges to squeeze the glue under. I removed the fabric pins after the glue had set but was not completely dry.
Step 7: Once the seat cushion and the bench base had both dried enough to handle, they were finally reunited!
I am quite happy with my new bench. Only thing I would have done differently would have been to try sewing or using Stitch Witchery to attach the ribbon to the top, as I was not completely happy with how the Liquid Stitch fabric glue dried. It was supposed to dry “invisible,” but I can still faintly see the glue lines through the ribbon even after it dried for over 24 hours. What can I say – that’s why an experiment is an experiment – they can’t all go swimmingly. It’s not that visible, but as a perfectionist I had to mention it. 😉
So there you have it folks, a $10 bench gets a makeover with for no more than the extra materials I already had on hand and a few hours spent in the spring weather on my back deck. Not too shabby!